Measuring for driveshaft.

1. All driveshafts should be measured "center to center of the U joints"

2. With the vehicle at ride height, install the transmission yoke.

Push it all the way into the trans.

3. Pull it out a min of 1", max 1 1/4"

4. Measure from the center of the U joint at the trans to the center of the U joint

at the rear end yoke.

5. It may be easier to measure from the back of the U joint caps front and rear.

6. This will be the diminsion which driveshaft shop will need.

7. Check with them as to which shaft to modify.

5/23/2009